![]() ![]() The next window lists all name-to-address bindings. This opens the "Edit Master Zone" window shown below. Scroll down a bit a locate the rectangle named "pixi.guide".Ĭlick the red pen symbol in the top right hand corner of this rectangle. This displays a window with a number of buttons at the top. Start by selecting "BIND DNS Server" under "Servers" in the list on the left hand side. The procedure for configuring and enabling the DNS server is similar to the one used for the DHCP server above. Click the green "Save" button at the bottom of the window if you make any changes. You can adjust those numbers as you see fit. In this example, we're allowing the DHCP server to dynamically allocate address in the 10.2.5.1 through 10.2.16.254 range, giving us loads of dynamic adresses, while all addresses below 10.2.5.1 can be used for fixed IP address, as those are off limits for the DHCP server. You typically want a small number of addresses reserved for network devices that need a fixed IP address (such as the BLOCKS Server itself). Here, you also specify the range of addresses allocated to dynamic clients. If you gave the server another IP address for some reason, you need to adjust the subnet address managed by the DHCP server accordingly, which is done in the "Network address" field. Hence, the BLOCKS server is in the "10.2.0.0" subnet, which is the subnet about to be managed by this DHCP server. This opens the configuration for this subnet.Īs you may recall from the "Network Configuration" section of the First Start article, we gave the server the IP address "10.2.0.10", with a netmask of "255.255.0.0" (or "16" as this is sometimes called). Return to the "DHCP Server" page and click the small, red pen symbol in the top right hand corner of the rectangle with the 10.2.0.0 IP address. If you have multiple ethernet interfaces, you may need to revisit Networking menu to learn about the proper network interface name. The exact name shown for your Ethernet interface (in the illustration above "enp2s0") may vary. In the list that appears, make sure that your Ethernet interface is selected, then click Save. Scroll down a bit and click the "Edit Network Interface" button. Click that item to open the "DHCP Server" panel. ![]() The DHCP server configuration is found under Servers/DHCP Server in the menu shown on the left hand side. The start screen of webmin shows some basic information about your server. You need to convince your web browser that this is normal, asking it to store a certificate exception for this server, thereby avoiding this warning in the future. This warning is caused by the kind of certificate used by webmin to encrypt the communication. You may see a warning message when first accessing webmin. Now, using another computer connected to the same network, open a web browser and type the following into the address bar (where is the IP address of your Blocks server) :Īlternatively, you may access webmin from a brower started on the server itself by typing into the address bar. The second command enables and starts webmin. ![]() This is required as the pixi-server user doesn't have the necessary privileges to enable system-level services. The first of those commands switches the terminal session to the pixi-admin user.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |